How to Add Shutters to Your House?

Hey everyone, about 2 months ago, I thought about giving my house a little upgrade by adding shutters to a house. I wanted shutters not just for looks, but to add privacy and protection. So I hired a professional to do the job. He informed me that the first important thing to add shutters is to measure and choose shutters that are the appropriate size for your window. I observed the process he followed, so sharing the same below.

How to Add Shutters to Your House Easily?

1. Measure the width and height of the window. 

2. Select shutters that are about half the width of the window and the same height as the window. 

3. Make use of a hacksaw blade to remove the old shutter. 

4. Now, position the new shutter against the window. 

5. Allow a small space (about 1/4 inch) to separate the window trim from shutters. 

6. You must mark the points with a pencil while the shutter is in position. 

7. For hinges, latches, or other hardware, drill pilot holes. 

8. Now, drill holes into the exterior of the home at the designated locations. 

9. If the screws don't tighten completely, use anchors and a masonry bit for brick. 

10. Make sure the shutter's mounting holes line up with the house's holes. 

11. Use the proper screws to fasten them. 

12. Finally, apply a weatherproof finish to the wooden shutters.

These are the steps the professional carpenter I hired followed and informed me. It requires extensive knowledge, so I suggest you better hire a professional carpenter.

Hire NoBroker Carpenter to Install New Shutters in Your House.

Hi Buddy,

Adding shutters to a home's exterior is a simple method to improve its curb appeal. Learning how to add shutters to your house is a simple project that can be finished in an afternoon with the correct equipment and some basic DIY abilities, depending on how many windows you have.

It will take an extra pair of hands to complete the installation, so make sure you have someone to assist you. When utilising a ladder to install shutters on a second storey, take the necessary safety precautions.

• Install a shutter bracket at the manufacturer's specified height on the stucco wall. Place a level on the bracket and, if necessary, straighten it. Mark the screw hole locations on the bracket using a pencil. Remove the bracket and set it aside.

• Depending on the structure your stucco covers, use a 1/8-inch drill bit or a 1/4-inch masonry bit. Drill bits are used to pierce a wooden construction. Masonry bits are used to drill holes in brick or concrete. Use wall anchors to assist secure the bracket to the stucco wall if you have a brick or concrete construction.

• Tap wall anchors into place with a hammer after pushing them into the pilot holes. The stucco siding should be flush with the wall anchor heads. If your stucco is covering a wooden building, skip this step.

• Align the screw holes in the bracket with the pilot holes or anchors in the wall. To secure the bracket to the stucco wall, use the supplied screws and a Phillips driver bit. Install the remaining brackets on the stucco wall in the same manner, as directed by the manufacturer.

• Placing the shutter on the brackets is the next step. Drill 9/64-inch pilot holes through the bracket's screw holes into the shutter's edges. Secure the shutter to the top and bottom brackets using the included screws. Replace the first shutter with the second.

I would like to conclude my answer here about how to add shutters to your house. I hope this helps:)

Read More: