How to Build a Flat Roof Extension?

Hi Buddy,

For a very long time, my father had planned to build a flat roof extension. But we had no idea how to build a flat roof extension. So, to help us with the process, we engaged a qualified house interior specialist from NoBroker.

Without a doubt, adding an extension to your home is one of the best methods to increase its size and value. Building an aesthetically pleasing, thoughtfully designed addition has many advantages, but getting it just right may be challenging.

The home interior expert guided me through the process of constructing various roof extensions like flat and pitched roof extension. I would like to brief you guys about the same.

How to build a flat roof extension?

Extension flat roofs are typically built similarly to wood floors, essentially with a set of joists and a timber deck affixed on top. It goes without saying that the size, type, and spacing of the joists must be correct.

The calculations of a structural engineer are typically required by building control to show that the finished structure will be able to withstand the various loads and resist wind uplift. The design must also take into account any roof windows, which necessitate the cutting, trimming, and strengthening of the joists, as well as additional loadings like expected foot traffic.

However, ensuring that the flat roof has an appropriate slope or "fall" to distribute rainwater is probably the most crucial design factor. If you do this incorrectly, water will gather in puddles and cause early damage. The Building Regulations recommend a 1:40 minimum fall (i.e. 40 units in length for every one unit drop in height)

How to build a lean to roof on an extension?

A pitched roof with a single slope is known as a lean-to roof. They are preferred for sheds because they enhance the volume of space that is accessible inside the structure. One of the simplest ways to attach the addition to an existing building is with a lean-to roof design.

• Mark the location where the structure will be built, indicating whether it will be an addition to the current structure or a distinct structure.

• To avoid damaging the current structure's foundation when excavating the hole, measure 8 feet away from the existing structure in the outer direction. Now create a large hole.

• After inserting the post, fill the hole with concrete to secure it in place.

• Measure 3 feet in the same direction away from the current post. Next, dig a new hole and insert the second post. For the third and fourth posts, repeat this technique. Ensure that the space between the posts remains the same as it was before.

• The supporting post would sit on top of the posts that have been given a notch.

• The supporting posts should now be correctly fixed by inserting them into the notches.

• Attach the metal purlins to the exterior of the previously installed posts as soon as the building is complete. This stage requires the use of nails to ensure that it is securely fastened.

• Use a nail gun to fasten it to the side of your existing building. Use the nail gun to drill in high-quality screws. To this will be affixed to the top of the rafters.

• The nail gun should be used to firmly fasten two planks onto the top of the construction at either end. In the middle of it, place a third plank as well.

• Set the roofing material on top of it by fastening wooden boards at regular intervals as you did before.

• Place the roofing material over the already-built foundation roof structure after measuring it out. With a drill and nails, screw it to the supporting structure of the roof.

• Install the desired trim as the side structure's cover to complete the project. Using a drill and nails, screw it to the building.

I hope this helps you in understanding how to build a pitched roof extension. Follow the above-mentioned steps to construct a pitched lean to roof.

Read More: