How to clean air cooler honeycomb pads?

The best and immediate cooling solution for your property as summer approaches can be met with air coolers. Moreover, the honeycomb pads are a crucial part of an air cooler. By absorbing moisture and allowing it to escape, these pads assist in cooling the air and lowering its temperature. It is critical to understand how to clean honeycomb pad of air cooler if you want to prolong its life and effectiveness of it. As my father is an AC Technician, I can help you out with the easiest cleaning steps.

How to clean honeycomb cooling pad?

The instructions for cleaning a honeycomb cooling pad have been provided by Saquib Memon, however, I believe they are quite lengthy. You can use the basic approach I described below:

• Unplug the air cooler from the power source after turning it off. 

• Disconnect the cooler unit's honeycomb pads. 

• Get rid of particles and dirt from the air filter with a soft-bristled brush or vacuum cleaner.

• If the filters are washable, use a mild cleaning solution to gently rinse the air filter. To prevent filter shrinkage, water shouldn't be above 40 °C.

• Before reinstalling the pads, give them time to fully dry.

• Put the dried honeycomb pads back into the air cooler with care. 

Make sure to get new filters if the old ones are broken. I hope you got an idea of the honeycomb pad cleaner steps.

Cleaning your air cooler pads is something you need to do once a year if you have a master air cooler. It is preferable to perform this when you first switch on your air cooler for the season. The process about how to clean air cooler honeycomb pads is as follows.

How to clean cooler pads?

1) Select a Day with Fine Climate

Make sure a pleasant day is chosen for this. If it's rainy or cloudy outside, you must avoid attempting to clean your swamp cooler pads.

2) Take the Cooling Pads Off

You have to get the pads out. They have a canvas cover and are in the cooler's front section.  you must remove the panel to take out the front cover. Once the front net covering has been removed, you may then remove the top panel, which will simply open up.

3) Inspect the State of the Pads

Once the pads are removed, make sure to inspect them. Are they dissolving? They obviously have a lot of salt water build-up and need to be changed. You must carefully move the pads from the roof to the floor for washing after being examined. This is one of the major parts of how to clean air cooler pads.

4) Clean the Cooling Pads

You have to take your pipe and then lean the pads downward. The routes inside each sheet will be indicated by diagonal lines on the sides. By doing this, you can push the trash through the pad. Start thoroughly cleaning each pad now. You may need new ones if you are washing your pads and the salt is still not going off easily.

5) Replace the Pads

Put the pads back where they belong. You have to be careful to examine the pads and install them properly. Place the transmission tube part back on top of the pads once you've replaced them. After replacing the front net panel, the top metal panel should be in position. The panels should then be screwed back together.

This way you will know how to clean air cooler honeycomb pads.