icons

Login / Sign up

Zero Brokerage.

Thousands of new listings daily.

100 Cr+ Brokerage saved monthly.

Enter phone to continue

Change Phone
Get updates on WhatsApp

Experience The NoBrokerHood Difference!

Set up a demo for the entire community

Thank You For Submitting The Form
Q.

How to Drill Door Knob Hole?

view 34 Views

2

3 months

Comment

whatsapp [#222222128] Created with Sketch. Send
0 2025-01-15T14:07:29+00:00

Recently, I took up a DIY project about replacing my bedroom door. I was aware of the steps that were necessary for installing the door but didn\'t know about lock installation. I started researching the lock installation process. The first step in installing a lock is to drill a door knob hole. I have shared the detailed process on how to drill door knob hole. below.

How to Drill Hole in Door for Door Knob?

The process of drilling a hole in the doorknob is rather simple. Here are the steps that you need to follow to get it done. 

  1. First, clean the surface of the door and measure & mark the desired height of the door. The height is generally 36 inches from the floor. 

  2. Now, set the jig and position it at the marked height. 

  3. After that, secure the jig in its place. 

  4. Take a drill and align it to the guide hole of the jig.

  5. Keep it perpendicular to the door\'s surface and start the drill. Ensure to apply steady pressure, but don’t force it.

  6. Once it passes through, stop the drill and do the same from the other end. 

  7. Next, follow the same process to make the latch hole as well. 

And that’s it. This is how you can drill a hole for a door knob. I hope you find this information helpful.

Hire Expert Carpenters through NoBroker to Install a Door Knob at Low Cost

Read More

How to Fill Drill Holes in Wall?

0 2024-11-13T09:05:17+00:00

My husband takes care of all the drilling work, so I can help you understand how to drill door knob hole. All you need is a good drilling machine and perfection to ensure perfect alignment. Start by marking where you want to have the knob, use your drilling machine, and drill the spot halfway through each side to prevent splintering. Then drill the latch hole in the door’s edge and make sure everything lines up perfectly.

How to Drill a Hole for Door Knob?

For drilling a doorknob hole, you will need a few tools, like a spade bit or hole saw, a smaller drill bit for the latch, a measuring tape, and a chisel for fitting the latch plate. Once you grab these, you will need to. 

  • Mark the spot where the knob and latch holes should go, and ensure to check that the height aligns with the knob placements.

  • Then use a spade bit or hole saw of the correct diameter 

  • Drill carefully through one side until the bit's tip barely pokes through the other side, then completes the drilling from the opposite side to prevent wood splinters.

  • Next, use a smaller drill bit and drill the latch hole in the door edge where the latch will sit. 

  • Finally, insert the latch and knob to check alignment. Now here, you might need to chisel a slight recess on the door edge so the latch plate sits perfectly.

This is how to make a hole for a door knob. With a good drilling machine and precision, you can do it at home. But yes, you need to focus on the alignment correctly, or else the knob won’t fit properly, so if you are not an expert, you better hire a professional.

Trust NoBroker Carpenters for Clean and Precise Drilling Works Every Time

Read More:

How to drill a Large Hole in Wood?

Most Viewed Questions

Recently Published Questions

Flat 25% off on Home Painting
Top Quality Paints | Best Prices | Experienced Partners