How To Install 12x24 Porcelain Tile?

The time when 12x24 porcelain tiles were only used in bathrooms is long gone. The kitchen, bathroom, living room, and bedroom are just a few examples of the places where these tiles are currently utilised, but they are now nearly everywhere because of their inventive patterns, textures, and designs. As a result, these tiles are employed extensively not only in residential but also in commercial contexts. However, installing porcelain floor tiles 12x24 is more difficult than installing porcelain tiles 12x12 in general.

But even if you've never installed tiles before, you can do it quickly with a little planning and by following the few suggestions below.

The following are the 6 stages for installing 12x24 porcelain tile on walls, and floors;

• Level the Surface:

The levelling of the floor is the first step in the tile installation procedure. For a number of reasons, including bettering tile interlocking and ensuring that the surface stays smooth and flat, making the surface even is essential. Uneven flooring will be caused by the uneven ground surface, which will not only affect the subsequent design but also seem ugly.

Additionally, an uneven surface increases the possibility of water collecting at a lower level area, which will ultimately degrade the tile quality over time. 

• Choose the Right Tile Mortar:

Picking the appropriate tile mortar is the next step once the surface has been levelled. Mortar, commonly referred to as thin-set, is a tile-attaching adhesive made of cement, fine sand, and a water-retentive component such as an alkyl derivative of cellulose. Three other kinds of mortars are also available: thin-set, mastic, and epoxy mortar.

The most typical tile mortar is thin-set, but since porcelain tiles are 12x24, I advise using medium-size or mastic mortar instead because it has a stronger holding ability. Additionally, using a thin set can cause your tile to become uneven and loose in some places as it dries and sets, which could lead to loose tiles.

• Use the Right Tools:

A quality set of tools is required for installing porcelain tiles on the floor, and walls. The use of the tools will ensure that everything proceeds according to plan while also speeding up the process. You'll need a drill, a saw, knee protection, a flat margin trowel, and other tools to instal 12x24 porcelain tiles.

• Keep the Work Neat & Clean:

Maintaining order and cleanliness during the tile installation process is another crucial aspect that you must not ignore. Immediately after completing the installation of the first 3–4 rows, wipe away any extra mortar from the tiles with a flat margin trowel to prevent it from drying out and hardening.

• Don’t Forget the Grouting:

Grouting is the following stage in the installation of 12x24 porcelain tiles. It is a crucial step in the installation of tiles and entails filling the spaces between the tiles. Grouting your tiles also gives them more rigidity and strength while keeping dirt and debris from getting between and under them. After grouting the entire floor, give it 20 to 30 minutes to dry. The extra grout should next be cleaned with a dense grout sponge that has been moistened.

• Clean the Tiles:

The porcelain tiles 12x24 still need to be cleaned after you've successfully accomplished all five of the earlier steps and installed them in your space. It will assist in removing paint, glue, mortar, and other contaminants from the tile's surface.

However, avoid using any caustic or acidic cleaning agents that could harm the tiles and give the grout some time to settle. Just soak the area for 10 to 15 minutes instead, then rub it with a soft brush or cloth.

I hope these steps would assist you with installing porcelain floor tiles. I hope this helps:)

Read More: