How to Install a Mixer Tap?

Hello, I saw you wanted to know how to fit a mixer tap and I can help you with the process. We recently got a mixer tap installed in our kitchen. So, I can show you the entire steps involving its installation.

How to Change a Kitchen Mixer Tap?

1. First, turn off the water supply and see that if you are replacing a tap, then the new tap should fit into the hole which is in your sink or worktop.

2. Remove the old tap by first unscrewing the two flexi tails and marking the hot water hose. Then, unscrew the tightening seal under the tap. Then, take off the tap.

3. With the help of the tap body, look for the centremost point on the worktop. Then, pre-drill a hole which measures 4 to 6 mm in diameter.

4. Drill a circular hole to match the new mixer tap’s exact dimensions. Sand down the edges of the hole you've created using fine grit sandpaper.

5. Next, screw the two flexi tails into the tap body with your hand. For safety, give an extra quarter turn with a pair of pliers.

6. Insert the threaded rod into the tap with the help of a flathead screwdriver and tighten it.

7. Clean the place where the mixer tap will be installed. Degrease it too. Insert the tap while making sure that the flexi tails don’t bend. 

8. Beneath the sink, position both the tightening seal and the washers. Screw everything well thereafter.

9. Before you tighten, make sure that the tap faces the correct direction. Connect the tap by screwing the flexi tails to your water supply pipes. Connect the hot and cold water lines to the appropriate pipes.

10. Turn on the water supply and test the hot and cold water. If there is no leakage and the temperature of the water can be changed by moving the lever, then the tap has been installed correctly.

This is how to fit a mixer tap. I hope this helps.

An inexpensive option to increase your kitchen's utility and convenience is to upgrade your mixer tap. I have recently done wall mixer fitting by following the tips provided by my plumber friend. The procedure will differ depending on the number of holes and the design of your kitchen sink, but it is still quite simple. Scroll down to learn how to fit a mixer tap on your own. 

How to install wall mixer tap?

A useful and easy task that must be completed in a few easy steps in installing a mixer tap.

• Acquire all the required equipment like the new mixer tap itself, an adjustable wrench, tape, and so on. 

• You must switch off the main water supply before starting the installation process. It is typically found below the washbasin. This will prevent any potential leaks or water damage.

• Using an adjustable wrench, begin by removing the water supply lines from the old tap.

• Before moving further, thoroughly clean the area to remove any dirt from the old tap.

• Now, do the new mixer wall fitting.

• Gently install the mixer tap into the available holes of the basin.

• Tighten the nut with the adjustable wrench until it is securely fastened. 

• Turn on the main water supply lines.

• Finally, tests the tap for leaks. 

The installation of the mixer tap is complete if the water runs freely and there are no leaks. I hope you got an idea of how to install a mixer tap.