How to Install a Pocket Door Into an Existing Wall?

I recently needed to install a pocket door which would slide open for the kitchen area of my new house. This is because I didn’t have enough space for a standard door which would swing open. I looked up the process of how to install a pocket door into an existing wall and found that it needs to be started by taking measurements. I have shared the detailed process I came across.

How to Install Pocket Door into Existing Wall?

Here are the simple instructions on how to go about it I came across:

• You must start by marking the dimensions on the wall and taking measurements of the area where I wanted the pocket door to go. 

• Carefully cut out the area to reveal the studs with a drywall saw. You must take time to make sure the cuts were clean. 

• Then you must follow the directions to install the header and track system. In order to ensure a smooth operation, make sure everything is level.

• You must use screws to secure the header, and then add split studs to provide a pocket that the door could slide into. 

• After assembling the frame, secure the door to the rollers and slid it into position. Use the wrench now to adjust the door's height. 

• Finally, finish off by painting it to fit your decor and add a wall around the frame. 

I hired a professional to install my pocket door, and I was happy with how well it fit into my house. I hope you found this answer helpful.

Read More:

Hi there,

I believe that the key to good interior designing today is smart designing. Smart designing focusses on space saving techniques which makes our home look very spacious while not compromising on the use. One such space saving smart idea I found was pocket door installation instead of normal swinging doors. It is a door that glides in and out of the wall. A hollow wall at least 36 inches long on one side of the current door is required. I think fixing a pocket door is a DIY project if you have basic home improvement skills. So, let me tell you how to install pocket door without removing drywall.

How to install a pocket door into an existing wall?

Before we understand the process of installing a pocket door, let’s see what things will be required for that.

• Kit for a pocket door

• Trimmers and king studs

• Stumpy studs

• Screwdriver

• saw with a circular blade

• Level Hammer with a Power Drill

Now let’s understand how to install a pocket door.

If you want to install a pocket door, you'll need to drill a hole in the existing structure and remove any studs on the interior. If you're labouring on a load-bearing wall, you should consult an expert first because it may result in severe structural alterations to your home.

If the site where you want to put your pocket door is adequate, you might want to consider purchasing a pocket door kit. You may purchase one with or without a door, but purchasing one with a door makes installation much easier. You may also repurpose an existing door.

Prepare the Task Area: Because the work will generate some dust and particles when you begin, ensure you cover everything with plastic cloths before you begin.

Taking Out The Old Door And Its Frame: Begin by removing the existing door. It might be as simple as disassembling the hinges and removing them. You'll also have to get rid of the existing door frame.

Construct Your Door's Rough Opening: To make the rough hole for your slider pocket door, you'll need to take a part of the current wall away. The rough opening is the area that will be used to install the framework and pocket door.

I hope I was able to properly explain how to install pocket door without removing drywall.